
Areas / Ovens
Lighting control in Ovens
Cork Lighting provides lighting control in Ovens, and the work we are asked for most here is cove and linear lighting with 0-10V and minimal modern kitchens. Our engineers cover Ovens from the Cork office, and every job starts with a consultation and ends with a written quote.
Local to you
Lighting control for Ovens homes
Ovens lies just west of Ballincollig, with newer estates near the village and Killumney, and one off houses spread across the countryside around it.
Modern one off houses around Ovens often have the clean, minimal details that suit linear and cove lighting, which is typically controlled with 0-10V drivers. Getting that right means choosing the drivers and cable routes before the plaster goes on. In a newer estate house the same effect can be had more simply, with dimmable fittings and a well matched dimmer.
Popular in Ovens
- Cove and linear lighting with 0-10V
- Minimal modern kitchens
- Pendant lighting on dimmers
- Estate house dimming upgrades
Most asked for here: 0-10V lighting control in Cork.
The control signal behind 0-10V dimming in Ovens is part of the lighting standards kept by the International Electrotechnical Commission.
Services
What we install in Ovens
Crestron lighting control in OvensOur main system: designed, installed and supported by 1Install.
Lutron lighting control in OvensHomeWorks and RadioRA 3: smooth dimming and elegant keypads.
Control4 lighting control in OvensControl4 dimmers, keypads and scenes for homes across Cork.
Lighting design in OvensRoom by room layouts, circuit schedules and control plans.
Lighting installation in OvensFirst fix cabling to commissioning, by one team.
Circadian lighting in OvensTunable white lighting that follows the day.There is no travel charge to Ovens for a consultation within the county. Book a consultation.
Lifetime warranty
Crestron lighting controls carry a lifetime warranty
Read how the Crestron lifetime warranty protects your lighting.
Questions we are often asked
Is cove lighting hard to dim?
Not if the driver and controller are chosen together. We plan it so the light fades evenly from top to bottom.
Do I need a different cable for 0-10V lighting?
Yes. A low voltage control cable runs to the driver as well as the mains, so it is best planned at first fix.
Can pendant lights be dimmed separately?
Yes. We put them on their own circuit so you can set the island or table light on its own.
Can you help with an estate house in Ovens?
Yes. We start with the living room and kitchen and extend from there.
Want advice on lighting for a job in Ovens? Call 021 202 8107 or send the details through our contact form and we will arrange a consultation.